A microprocessor is a chip that dependent on the chip of many function.

A microcontroller is a single chip microcomputer that has everything in built.

Microprocessors are often at least 16-bit, and typically 32-bit or 64-bit, though 8-bit still has a big market share.

Microcontrollers  are typically 8-bit, but may be 4-, 16-, or 32-bit

It has few bit manipulation instruction.

It has many bit manipulation instruction.

Microprocessors  run at speeds measured in hundreds of MHz

Microcontrollers  run at speeds less than 200 MHz

It has less number of multifunctional pins

It has more number of multifunctional pins.

They have large memory address space.

They have small memory address space.

Design is very flexible.

Design is less flexible.

CPU is stand-alone, RAM, ROM, I/O, timers are separate.

CPU, RAM, ROM, I/O, timers are all on a single chip.

Expensive device.

For application in which cost, power & space are critical.

General Purpose.

Single Purpose (Control- Oriented).

High processing power.

Low processing power.

Rapid movements of code & data between external memory & MP.

Rapid movement of code & data within MC.

Microprocessor instructions are mainly nibble or byte addressable.

Microcontroller instructions are both bit addressable as well as byte addressable.

Microprocessor based system design is complex.

Microcontroller based system design is rather simple.

Microprocessors  need special hardware to interface with sensors, motors, LEDs, etc.

Microcontrollers are useful to interface with sensors and motors.

A microprocessor has zero status flag.

A microprocessor has no zero flag.

Microprocessors are based on von Neumann model/architecture where program and data are stored in same memory module

Micro controllers are based on Harvard architecture where program memory and Data memory are separate

Most of the microprocessors do not have power saving features.

Most of the micro controllers have power saving modes like idle mode and power saving mode. This helps to reduce power consumption even further.

Since memory and I/O components are all external, each instruction will need external operation, hence it is relatively slower.

Since components are internal, most of the operations are internal instruction, hence speed is fast.

Microprocessors are not as easily worked with by a hobbyist.

Microcontrollers are really nice for electronics hobbyists.



Difference between Microprocessor and Microcontroller

No comments:

Post a Comment